Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may locate that your garage door opener has been offering you troubles, so you need to repair it. You can fix it by changing a circuit card, a photo-eye sensing unit, the main drive equipment, or the set-limit buttons. You can additionally check if the safety and security sensors are working effectively.

Replacing a motherboard

Changing a circuit card for your garage door opener requires a few steps and also tools. First, you require to switch off the circuit breaker and also disconnect any kind of cords. Next, open up the motherboard cover. This will assist you to diagnose the issue and also determine if you need a brand-new board. Next off, remove the old board and its wire connectors.

You can after that continue to replace the circuit board. The substitute process is very easy as well as takes about 10 mins. A new circuit card will certainly cost concerning $80. To protect your new circuit board from power rises, you can buy a rise guard.

Replacing a photo-eye sensor

Changing a photo-eye sensing unit can be a fairly basic job. Initially, eliminate the sensor from the door and see to it is positioned appropriately. If the sensor is angled by any means, it might not be getting the correct signal, which can be causing the blinking lights. If you notice that the photo-eyes are out of placement, you might require to have actually a specialist come as well as fix the trouble.

The photo-eye sensor contains 2 items that place outside of the door tracks and towards the floor. The image eyes will certainly have a small LED light and must be solid in shade. If the light is blinking, its likely the photo-eye is defective and also will need to be replaced.

Replacing a major drive gear

To replace a garage door opener primary drive equipment, beginning by removing the cap from the chain pulley-block. Next, eliminate the two screws holding the drive gear to the sprocket assembly. Now, you can unfasten the 3 stress pins. Squeeze them from both sides and after that eliminate them. After that, separate the 3 wires from the garage door opener motor. These wires need to be white, red, and blue.

Once you have actually eliminated the old equipment, mount a new one. Make sure to grease it well. Put the new equipment right into the shaft, making certain to line up the mounting openings. Make certain the gear as well as sprocket assembly are positioned appropriately to ensure smooth procedure. Next, use a hammer as well as a nail to drive a pin right into the brand-new gear.

Readjusting the set-limit switches

The very first point you must do if your garage door is not functioning properly is to examine the set-limit switches. You might need to adjust them so that the door shuts earlier or quits prior to it reaches the floor. You can inspect this by considering your garage doors manual or online.

To change the set-limit buttons, youll need a screwdriver or socket. Readjust the knob clockwise or counterclockwise until the door goes up and quits, or minimizes its range. To look for correct traveling range, determine the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488