Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair
You may locate that your garage door opener has been giving you troubles, so you need to repair it. You can repair it by replacing a motherboard, a photo-eye sensor, the major drive equipment, or the set-limit buttons. You can likewise check if the safety and security sensing units are functioning appropriately.
Changing a circuit board
Changing a circuit card for your garage door opener requires a couple of actions and devices. Initially, you require to turn off the breaker and also separate any type of wires. Next off, open the circuit card cover. This will assist you to detect the trouble as well as figure out if you need a brand-new board. Next, eliminate the old board and also its cord ports.
You can then proceed to replace the circuit card. The replacement process is easy and takes around 10 minutes. A brand-new circuit card will certainly set you back regarding $80. To shield your new circuit card from power rises, you can purchase a surge protector.
Replacing a photo-eye sensor
Replacing a photo-eye sensor can be a rather basic task. Initially, eliminate the sensing unit from the door and see to it is positioned correctly. If the sensor is angled in any way, it might not be getting the appropriate signal, which can be triggering the strobe lights. If you notice that the photo-eyes are out of placement, you might require to have a specialist come and also deal with the issue.
The photo-eye sensing unit includes two items that mount on the outside of the door tracks and toward the floor. The image eyes will have a little LED light as well as need to be strong in color. If the light is blinking, its likely the photo-eye is defective and also will need to be changed.
Changing a major drive equipment
To replace a garage door opener major drive gear, begin by getting rid of the cap from the chain sheave. Next off, eliminate the two screws holding the drive equipment to the sprocket setting up. Now, you can unfasten the 3 tension pins. Press them from both sides and then remove them. After that, disconnect the three cords from the garage door opener motor. These cables must be white, red, and blue.
Once you have removed the old equipment, mount a new one. Be sure to oil it well. Insert the brand-new gear into the shaft, making sure to align the placing openings. Ensure the gear and also sprocket assembly are positioned correctly to ensure smooth operation. Next off, make use of a hammer and a nail to drive a pin into the new gear.
Readjusting the set-limit buttons
The very first point you need to do if your garage door is not functioning properly is to inspect the set-limit buttons. You might require to adjust them to make sure that the door shuts earlier or quits prior to it reaches the flooring. You can examine this by looking at your garage doors handbook or online.
To change the set-limit buttons, youll need a screwdriver or outlet. Adjust the knob clockwise or counterclockwise up until the door moves up and also quits, or lowers its range. To look for correct traveling range, determine the gap from all-time low of the garage door to the ground.
Veteran Garage Door Repair – Keller
204 S Key St Ste 105, Keller, TX 76248, United States
817-769-8488
https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/
![]() |
![]() |
![]() |
![]() |
![]() |
Veteran Garage Door Repair
204 S Main St Ste 105
Keller,TX
76248
817-769-8488
https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/