Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may locate that your garage door opener has been providing you issues, so you need to repair it. You can repair it by replacing a circuit board, a photo-eye sensor, the primary drive equipment, or the set-limit buttons. You can also examine if the safety sensing units are functioning appropriately.

Changing a motherboard

Changing a circuit card for your garage door opener needs a couple of actions and also tools. First, you need to turn off the breaker and also disconnect any kind of cords. Next, open up the circuit card cover. This will certainly aid you to detect the issue and establish if you require a new board. Next, get rid of the old board and also its cable adapters.

You can then proceed to replace the circuit board. The replacement process is very easy and also takes about 10 mins. A brand-new motherboard will certainly set you back about $80. To safeguard your brand-new circuit board from power rises, you can purchase a surge protector.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensing unit can be a rather simple job. Initially, remove the sensor from the door as well as make certain it is positioned appropriately. If the sensor is angled at all, it might not be obtaining the appropriate signal, which can be causing the blinking lights. If you discover that the photo-eyes run out placement, you might need to have actually a specialist come as well as repair the trouble.

The photo-eye sensor contains two pieces that mount outside of the door tracks and toward the flooring. The photo eyes will certainly have a tiny LED light as well as need to be strong in shade. If the light is blinking, its most likely the photo-eye is defective and will require to be replaced.

Changing a main drive gear

To change a garage door opener major drive gear, beginning by removing the cap from the chain sheave. Next, eliminate both screws holding the drive equipment to the gear setting up. Currently, you can unfasten the 3 stress pins. Press them from both sides and afterwards remove them. After that, disconnect the 3 cords from the garage door opener electric motor. These cables ought to be white, red, as well as blue.

When you have eliminated the old equipment, mount a brand-new one. Make certain to oil it well. Insert the brand-new gear into the shaft, ensuring to line up the placing holes. Make sure the gear and sprocket setting up are positioned appropriately to ensure smooth procedure. Next, make use of a hammer and a nail to drive a pin into the new equipment.

Changing the set-limit buttons

The very first thing you need to do if your garage door is not working properly is to check the set-limit buttons. You may require to adjust them so that the door shuts earlier or quits prior to it gets to the floor. You can examine this by considering your garage doors handbook or online.

To readjust the set-limit buttons, youll need a screwdriver or outlet. Readjust the handle clockwise or counterclockwise up until the door goes up and also quits, or reduces its distance. To look for proper travel range, measure the space from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Back To Top